This procedure is not valid for :
Drivo - Drivo2 - Direto - Direto X - Kura
Login on My E-Training app and configure your trainer
Then, press on "Parameters" -> "Advanced Configuration"
If you haven't configured an external power-meter yet on the app, click on "Power sensor serial", choose the protocol for the connection with the power meter, then select it on the list.
Then just click on "Calibration Wizard" and follow the procedure.
If you don't a Power-meter, click on P1, P2, P3 and modify the value of P1 and P2 as follows:
- If the resistance is too high respect the power sent by the trainer increase P1 and P2 of 20 points each
- If the resistance is too low respect the power sent by the trainer decrease P1 and P2 of 20 points each
Notes: P1 and P2 values are directly connected with the uphill conditions ( respectively 20km/h and 30 km/h ), P3 value manages the flat road conditions ( 40 km/h ), so usually is not necessary to modify it. If necessary, just repeat the same procedure as P1 and P2.
After the modification, you need to check the result and if necessary repeat the procedure till you find the correct combination ( after the first modification, remember to modify the value you just modified.
THE APP SHOWS ALWAYS THE ORIGINAL VALUE, NOT THE LAST INSERTED)