Follow

Calibration wired

The first test is to understand if the trainer do the homing procedure ( the little motor on the trainer which move the magnets arm ).

Please power off the trainer, then power it on and check if the on the black plastic cover you can feel any vibration.

Then on this link AxtoTest.zip you will find a little program.

Unzip it, run it and follow the following instruction : 

 - Power on the trainer
 - Connect the console to the computer with the USB cable.
 - Connect the console to the resistance unit with the Ethernet cable.
 - Push "Find device" button ( in red )
 - Start to pedal

- Controllare i tre valori di resistenza seguendo questa procedura

 

P3 = write 0 on the “Resistance value” label ( in purple ) and then try to pedal at 40 km/h and when the value on the ergometer is quite stable, record the value of wattage you can see on the Powertap .

P2 = write 60 on the “Resistance value” label ( in purple ) and then try to pedal at 30 km/h and when the value on the ergometer is quite stable, record the value of wattage you can see on the Powertap.

P1 = write 100 on the “Resistance value” label ( in purple ) and then try to pedal at 20 km/h and when the value on the ergometer is quite stable, record the value of wattage you can see on the Powertap.

 

The new three values ( P1 - P2 - P3 ) became the new calibration values on the Real software ( you can insert them on “Settings” -> “Modify Calibration values” ) .

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk