Follow

Calibration ANT - PA and PB ( for RealTurboMuin )

NOTE: To do the calibration, you must have a bicycle with a tool to detect the power ( ergometer like PowerTap, SRM - etc . ).

THIS CALIBRATION IS COMPATIBLE WITH REALTURBOMUIN ANT

THIS CALIBRATION IS NOT COMPATIBLE WITH REALTURBOMUIN B+

 

The calibration procedure allows you to tell the program exactly how much resistance generates the roller & bike on two different conditions of speed and endurance. In this way the program is able to display and brakes more accurately compared to standard conditions.

For this reason it is necessary to pedal at 2 different speeds with different resistance settings.

During the test it is necessary to take note of the power values ​​shown on the ergometer .

 

The operations to do it are the following :

- Download this file AxtoANT

- Unzip the file to the Desktop

- Power off the unit

- Check that the ANT USB stick  is plugged into the computer

- Re-insert the power supply jack ( now the step motor moves inside this unit , producing a small vibration for a few seconds )

- Run the software AxtoANT previously unzipped to the Desktop

- Change the value of "Roll diameter " as 150( see picture with " Yellow " arrow)

- Uncheck the HR and Console box upper the Green button.

- Press the “Connect” button , as in the image and "Green" arrow

 

- Wait until a confirmation message appears on the screen, "Connesso" ( connected ) 

- To check that the unit is connected, press the "Update" button, as shown in the picture with the "Blue" arrow  and check the unit serial number under " Trainer" ( comparable with the value written under the unit) .

- Check that speed values ​​are read, by pressing the "Start" button , as indicated by the arrow in the image with "Black"

 

Calibration of the 2 values:

 

- Enter the number 15 inside the box , and press " Send Resistance " as in the picture with the " Red " arrow.

- Pedaling at a speed of 30 km / h , you can check the speed through the panel to the left of the blue box .

- Take a note of the power value you can read on the ergometer, try to read it when it is quite stable and mark it on a separate sheet as PA.

 

- Enter the number 77 inside the box , and press " Send Resistance " as in the picture with the " Red " arrow.

- Pedaling at a speed of 30 km / h , you can check the speed through the panel to the left of the blue box .

- Take a note of the power value you can read on the ergometer, try to read it when it is quite stable and mark it on a separate sheet as PB.

  

Then click on Disconnect, Close the software AxtoANT, and run the software Real.

Over the connection, click on "Settings" -> "Calibration Resistance Unit", and insert the two values PA - PB just found.

Confirm with OK.

 

Now try to do a training and check if the resistance is correct.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk